![]() ![]() First, make sure that the power to the heater is turned off. If your water heater element is stuck, there are a few things you can do to try and remove it. How to Remove a Screw-In Water Heater Element That is Stuck Be sure to hand-tighten the nuts before turning on power to avoid over-tightening and damaging them. Once the nuts are loose, you can remove the old element and replace it with a new one. You may need to use a little force to loosen them. Loosen the nuts that hold the element in place with the pliers, being careful not to damage them. Then, remove the access panel and insulation if necessary to get to the element. Just be careful not to damage the element with the pliers.įirst, turn off the power to the water heater. If your water heater element wrench is missing or damaged, you can use a pair of pliers as a substitute. Once finished, close off both valves and restore power and water supply before turning on your taps again for hot water service. Place the other end of the hose in a nearby sink or floor drain and let gravity do its job until all the water has been emptied from the tank. Next, attach a hose to the drainage valve and open it up. To drain your water heater, start by shutting off power to the unit and cold water supply. However, if you’re performing more extensive work such as changing the heating elements or sediment buildup is excessive, then draining will be necessary.ĭraining also needs to be done if the unit is being replaced entirely. These types of repairs can be made with the unit full of water. If you’re simply replacing a component such as the thermostat or anode rod, there’s no need to drain the tank. However, there are a few circumstances where draining may be necessary. The good news is that in most cases, you won’t need to empty the tank before making repairs. If you need to make repairs or changes to your water heater, you may be wondering if you need to drain the unit first. Can You Change the Elements on a Water Heater Without Draining It? If all else fails, you may need to replace the element. This will expand the metal and hopefully loosen the element. If it’s still stuck, you can try heating up the element with a blow dryer or heat gun. Then, using a wrench or pliers, carefully unscrew the element from the housing. First, make sure that the power is off to the water heater. If your water heater element is stuck, there are a few things you can try to loosen it. How Do You Loosen a Stuck Water Heater Element? ![]() Make sure to get one that’s adjustable, as this will make it easier to get a tight fit. Once you know the size of your element, head to your local hardware store or home improvement center to pick up the right wrench. You can usually find the size of your element printed on the side of the tank. The most common sizes for water heater elements are 1/2″, 5/8″, and 3/4″. If you need to replace the heating element in your water heater, you’ll need a wrench that fits the size of the element. What Size is a Water Heater Element Wrench? Whichever tool you use, make sure to turn off the power to your water heater before you start working. You can also use a pair of pliers, although you’ll need to be careful not to damage the nuts. A socket wrench or an adjustable wrench will work, as long as it’s the right size for the nuts on your water heater. ![]() If you don’t have a water heater element wrench on hand when you need to replace your water heater’s elements, there are a few other tools that can do the job. What Can I Use Instead of a Water Heater Element Wrench? How to Remove a Screw-In Water Heater Element That is Stuck.Can You Change the Elements on a Water Heater Without Draining It?.How Do You Loosen a Stuck Water Heater Element?.What Size is a Water Heater Element Wrench?.What Can I Use Instead of a Water Heater Element Wrench?. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |